CERAKOTE CTC-997 PU HQ

Application Procedures :

1. Clean bathtub to be painted from dirt, crust, fungus and other contaminants, sand thoroughly with sand paper #240 – 400, depend on subtrate condition. For metal bathtub, must be clean the surface from rust then apply anti corrosion paint (zinc chromate/ zinc phosphate).
2. Mix one set of primer coat (CERAKOTE CTC-980 primer) with mixing ratio by weight com. A : comp. B = 4 : 1. For application using spray gun, add epoxy thinner Polyurethane Thinner (PU) 5 - 10%. stir until homogenous, mix as needed. The mixture will harden in 45-60 minutes.
3. Apply mixed material with epoxy roller/brush, just a single layer with good spreading and sufficient thickness as needed.
4. If the existing bathtub still good, just the painting doesnt look shiny, apply directly with CERAKOTE CTC-997 PU HQ.
5. After base coat (CERAKOTE CTC-980 primer) is dry minimal overnight (12 hours), sand through;y with sand paper #400 and then clean the surface from dirt and other contaminant before apply top coat CERAKOTE CTC-997 PU HQ.
6. Mixed one set of CERAKOTE CTC-997 PU HQ with mixing ratio by Volume comp. A : comp. B = 2 : 1, add Polyurethane thinner (PU) 10-20%, stir until homogenous.
7. Apply mixed material using spraygun. For best result using HVLP spray gun (High Volume Low Presure). For the top coat can be applied just a single layer with good spreading and sufficient thickness as needed. Coverage is 3 – 4 m?2;/L-set.