EPOGREEN EPG-233-2K WB
Advantages :
- Water based two component (2K) system
- as a primer and top coat
- Strong adhesion to concrete
- Fast dry
- Horizontal and vertical application
- Odorless
- Interior and exterior application
- Non yellowing
- Excellent abrasion resistant
- Doff finish
- Easy to clean
- You can do it by your self, (using brush, roll and spray)
Packaging :
- 10 kg-set (Epogreen 2 komponen)
- 40 kg-set (Epogreen 2 komponen)
Color Card :
.jpg)
Video Training Product
Application Procedures :
Gunakan produk EPG-233-2K WB untuk lapisan primer dan top coat dengan mencampurkan komponen A dan komponen B dengan perbandingan berat 1 : 1. Aduk menggunakan mixer.selama 1-2 menit.
Untuk lapisan primer dan top coat :
Tuangkan produk yang sudah dicampur dke lantai dan tarik dengan menggunakan rubber squeegee, lalu ratakan menggunakan rubber roller. Konsumsi material adalah 0,23 kg-set/m2/lapis dengan ketebalan kering 100 miicron untuk masing - masing lapisan primer dan top coat
Tips Finishing Epogreen :
• Pastikan permukaan substrat kering dan bersih dari semua jenis kontaminan
• Sebelum melakukan aplikasi, permukaan substrat harus di grinding terlebih dahulu
• Gunakan roll dan alat aplikasi yang berkualitas baik
Tips :
* Epogreen harus diaplikasikan per lapis dengan ketebalan 100mic
| EPOGREEN EPG-233-2K WB | |
| Color | Clear, Blue, Beige, Ash Grey, Srikaya, Mint, Grey, Green |
| Finish | Doff |
| Specific gravity (mix) | 1.17 ± 0.04 |
| Solid by weight (mix) | 48% ±0.05% |
| Packaging |
10 kg-set (compA = 5kg, compB = 5kg) 40 kg-set (compA = 20kg, compB = 20kg) |
| Recommended thickness | 2 x 150 mic DFT |
| Mixing ratio (by weight) | Comp A : Comp B = 1 : 1 |
| Pot life | 30 minutes (30oC) |
| Storage stability | 24 months if stored cool and dry and in original packaging (not opened) |
| Flash point | Non flammable |
| Drying time |
Surface dry : 2 hours (30°C) Hard dry : 20 hours (30° C) Full cure : 7 days (30° C) |
| Application tools | Epoxy roll, squegee, spiked roll |
| Thinner | Clean water |
| Thinning ratio | 5 – 10% |
| Re coating interval | Minimum 6-8 hours (30°C) |
| Application temperature |
Minimum 20°C Maximum 40°C |
| Humidity maximum | 80 % RH |
| Material consumption | 0.23 kg-set/m2for ±100 microns DFT |
| • Provide adequate ventilation during application and drying | |
