FIBERKOTE FBK 888 / FBK 889

APPLICATION PROCEDURES

Surface Preparation

1. Check the whole surface that will be coated, seal the screw heads using appropriate cements. Allow to dry, scrub well and wipe out all dusts.
2. Moisture content of substrate must be ? 16% measured by Protimeter and alkalinity (pH) of substrate must be 7 – 8 measured by universal pH indicator.
3. Sanding lightly along the grain with sandpaper no. 240 and clean well (optional).
4. Surface must be dry, clean, free from dirt, dust, mold, oil and all contaminants. Clean any area affected by mold, moss and fungus with FUNGICIDAL WASH.

Primer coat :

1. FIBERKOTE Penetrating Sealer FPS-820 (Solvent Based). Apply 1 coat by brush, without thinning. Material consumption : ± 200 ml / m?2; (± 5 m?2; / liter).
2. Allow to dry, minimum 2 hours (depends on temperature and

Top coat :
FIBERKOTE FBK-888 / FBK-889, thinning with 10% - 20% clean water according to application need. Apply 2 - 3 coats by brush, with recoating interval minimum 2 hours (depends on temperature and humidity).

For applications on the floor / deck :

1. Apply FIBERKOTE FBK-888, follow the application procedure above. After fully dry at least 24 hours (depends on temperature and humidity), apply PROPAN USE-60 CLEAR GLOSS, 2 coats by brush / spray, with recoating interval minimum 4 hours.
2. Leave to completely dry for three to five days before usage.